Please ensure substrate is clean using No 40 Degreaser.
Prime substrate as required - onto normal ferrous metals, a full even coat of Universal HB Primer should be used. For non-ferrous substrates please initially apply TP2 Primer to ensure adequate adhesion. If thinners are required, add No 99 QDT Thinners up to 10% by volume.
In normal ambient air temperatures, SYNTOP Enamel will be hard dry to handle after 4 hours but this process may be accelerated by heating with good airflow - temperatures between 50c-70c are advised for 20 minutes, after an initial 15 minute flash off period.
May also be applied by brush, allow 12 hours between coats.
For further technical information, please contact ISF Technical Services.
Environmental Considerations: Please ensure the product is applied in temperatures above 10c. Applications below this temperature would mean the solvents will not be able to evaporate correctly, this could then lead to the product "blocking out" (not drying). If applying the product in high salt environments it is recommended that a DFT of 300 microns minimum (top coat & primer combined) is applied. Do not apply to wet or damp surfaces, all damp areas must be fully dried before being painted.